Lumen CS20 Slim - Tesla Model Y extra light

The slim version of the CS20 Performance!
A narrow LED bar with only one thing in focus - pure performance and the most possible light intensity. This high performance, without any boost tricks, is only possible through a proper development process, where lamps are designed specifically for Nordic conditions. It has double approval, so it is in practice two approved lamps in one lamp. And the light pattern is optimized to provide maximum brightness.

The CS20 Performance Slim has an output of 21,352 lumens and a throw of almost one kilometer. With a curved design, the lamp will follow the natural curve of the car's front bumper for a sleek and discreet installation. The frameless design makes it easier to keep the lamp free of ice and dirt throughout the winter months. The CS20 also has a brother, the S20 performance. The difference between the two is that the CS20 is curved at the front, while the S20 is straight. We believe that most cars fit the CS20 better, because it aligns with the car's curved front. The S20 is for cars with a flat front. The Performance series is all about getting the best possible light, it's pure performance! The slim profile makes it easy to install on most cars.

Wide beam - Perfect as a high beam!

Developed to provide an incredibly good beam pattern that suits typical Scandinavian conditions. The beam pattern is carefully optimized to provide as much light as possible, spread horizontally across the road, with an extra spot in the middle. We believe this is the absolute perfect beam pattern in a headlamp. You get a throw of 950 meters and also a good width in the beam pattern. The beam pattern is very similar to the Lazer Linear 18, but you get even more throw in the center of the road, which has been missing on the Linear 18.

Supplied:

• 1 pc Lumen Helios CS20 Performance Slim,
• Mounting brackets

ALC control current adapter for mounting additional lights on your Tesla Model 3, Y and S 2022+ (Plaid and long rage).

With support for adaptive high beams (matrix)!

The LED lights in the Tesla Model 3, Y and S 2022+ (Plaid and long rage) are controlled via a data stream from the car's computer, and you therefore need a very special adapter to control additional lights so that they turn on and off together with the car's original high beams. We have therefore developed this adapter - which we call ALC.

The adapter has been developed specifically to provide 12V control current for additional lights that can be led for the Tesla Model 3, Y and S 2022+ (Plaid and long rage), and is plug & play with the headlights and wiring in the car so that you don't have to cut cables and connect you manually with soldering etc.

It is also possible to permanently switch off the additional main beam in dense fog, snow or the like.

See recommended additional lights and accessories at the bottom of the page.

Delivered:

• Plug & play wiring harness and control box for Tesla Model 3, Y and S 2022+ (Plaid and base)
• ALC cannot drive the led bar - you need a relay kit as well

This is a complete relay set that has DTP 2-pin connectors attached for a plug and play solution for lights that have this connector.

This relay set is a great alternative if you are going to install, for example, Lumen's new Performance series. With the DTP connectors, you get a plug and play solution between the relay set, the battery and the lamps. In addition, you get a switch that has a small diode, but switches can also be removed if you don't want to use this. The DTP connector is a special connector, and is only used on larger beams that require a lot of power.