Lumen CS20 Performance - Tesla Model Y Juniper - extra high beam

Lumen CS 20 Performance with only one thing in focus - pure performance and the highest possible brightness. Just pure performance!

High performance, without playing tricks with boost, made specifically for Nordic conditions!
The lamp has double approval, so it is in practice two approved lamps inside one lamp. And the slide is optimized to provide maximum brightness. Really a fantastic lamp.

The CS20 Performance has an effect of an incredible 22,984 lumens, and a throw length of almost a kilometer. Here you get a rawhide of a lamp!
With a curved design, the lamp follows the natural curve in the front bumper of the car so that you get a nice and discreet installation. Frameless design makes it easier to keep the lantern ice-free and dirt-free throughout the winter. The CS20 also has a brother, the S20 performance. Where the difference between the two is that the CS20 is curved at the front, while the S20 is straight. On the vast majority of cars, the CS20 fits better where it flows with the car's curved front. S20 is for cars with a flat front.

The Performance series is about getting the best possible light, but a slim profile also makes it easy to mount on most cars.

Combo beam pattern - Perfect as a high beam

Developed to provide an incredibly good slide that suits typical Scandinavian conditions. The light image is optimized for as much light as possible, spread horizontally over the road, with an additional spot in the middle. The perfect slide in a spotlight! You get a throw length of 976 meters (0.25 lux) and, in addition, a good width in the slide. The slide is very similar to the Lazer Linear 18, but you get a bit more throw in the center of the fairway, which has been missing on the Linear 18.

ALC control current adapter for mounting additional lights on your Tesla Model 3, Y and S 2022+ (Plaid and long rage).

With support for adaptive high beams (matrix)!

The LED lights in the Tesla Model 3, Y and S 2022+ (Plaid and long rage) are controlled via a data stream from the car's computer, and you therefore need a very special adapter to control additional lights so that they turn on and off together with the car's original high beams. We have therefore developed this adapter - which we call ALC.

The adapter has been developed specifically to provide 12V control current for additional lights that can be led for the Tesla Model 3, Y and S 2022+ (Plaid and long rage), and is plug & play with the headlights and wiring in the car so that you don't have to cut cables and connect you manually with soldering etc.

It is also possible to permanently switch off the additional main beam in dense fog, snow or the like.

See recommended additional lights and accessories at the bottom of the page.

Delivered:

• Plug & play wiring harness and control box for Tesla Model 3, Y and S 2022+ (Plaid and base)
• ALC cannot drive the led bar - you need a relay kit as well

This is a complete relay set that has DTP 2-pin connectors attached for a plug and play solution for lights that have this connector.

This relay set is a great alternative if you are going to install, for example, Lumen's new Performance series. With the DTP connectors, you get a plug and play solution between the relay set, the battery and the lamps. In addition, you get a switch that has a small diode, but switches can also be removed if you don't want to use this. The DTP connector is a special connector, and is only used on larger beams that require a lot of power.